After letting the clear coat cure for 24 hours I bolted on the fixtures.
Next, using the technique from Blueglow Electronics I made the grounding bus and attached it:
Prev: Test fit, Prime, and Paint
Jul 6, 2019
Label, Clear Coat, and Grounding
I used Rub-on Dry Transfer letters to label the amp and then applied several coats of clear in one session, a few minutes in between coats
After letting the clear coat cure for 24 hours I bolted on the fixtures.
Next, using the technique from Blueglow Electronics I made the grounding bus and attached it:
Prev: Test fit, Prime, and Paint
After letting the clear coat cure for 24 hours I bolted on the fixtures.
Next, using the technique from Blueglow Electronics I made the grounding bus and attached it:
Prev: Test fit, Prime, and Paint
